中文  |   English

联系我们

电话:0312-3013660

传真:0312-3013660

手机:18233233061

行业新闻
造型机故障检测之震击部分
造型机故障检测之震击部分
Shaking part of molding machine fault detection
造型机发生震击无力或不震击有如下几种原因。
There are several reasons why the molding machine can't shake or can't shake.
1、造型机故障检测遇到空气滤清气堵塞,由于真空泵工作过程产生一些水份,长时间加上管路中一些异物便将空气滤清气中的滤芯堵死,压力表此时看着压力不小,但空气流量不够,造成机器震击无力。
1. In the process of molding machine fault detection, air filter air is blocked. Due to some water produced in the working process of vacuum pump, the filter element in air filter air is blocked for a long time plus some foreign matters in the pipeline. At this time, the pressure gauge looks like the pressure is not small, but the air flow is not enough, resulting in the weak shock of the machine.
2、由于长时间震动,会出现以下造型机假山制作 不锈钢铸件 铝箔真空袋 七孔梅花管 hdpe硅芯管 液压钢坝 PVC软管 飞行激光打标机 沥青保温泵故障:联接震定台与震击活塞的6条M20内六角钉松动,使震台与活塞之间有间隙,工作气流从此处泄漏,造成震击无力,特别是压实后不能震击。
2. Due to long-time vibration, the following molding machine failures will occur: Six M20 hexagon nails connecting the shaking table and the shock piston are loose, which makes the gap between the shaking table and the piston, and the working air flow leaks from this place, resulting in weak shock, especially after compaction, it can not be shaken.
3、活塞与泵铁之间不润滑,发生锈蚀,也可造成震击无力,解决造型机故障,可打开通往震实台的橡胶管,注入一斤左右的煤油或汽油,然后上好,开机震击,这时震击的声响会有很明显的变化。
3. There is no lubrication between the piston and the pump iron, which may cause corrosion, and also cause weak shock. To solve the problem of molding machine, open the rubber pipe to the shaking table, inject about a jin of kerosene or gasoline, and then get better, start up the shock. At this time, the sound of shock will change obviously.
  1. 电话:0312-3013660
  2. 传真:0312-3013660
  3. 手机:18233233061
  4. 备案号:冀ICP备18002375号

版权 © 保定市乐通机械设备科技有限公司  推荐:垂直造型线,静压造型线,自动浇注机,半自动浇注机  网站制作:保定遨游公司